Dometic refrigerator · 1 model line
Dometic refrigerator code LP
The RM3762/RM3962 operating instructions say a flashing LP message alternating with the fresh-food temperature means LP gas ignition failed after a complete ignition sequence and the burner did not light.
What code LP means by model
| Model line | What the manufacturer says | Source |
|---|---|---|
| Dometic RM3762 / RM3962 | The RM3762/RM3962 operating instructions say a flashing LP message alternating with the fresh-food temperature means LP gas ignition failed after a complete ignition sequence and the burner did not light. | Dometic RM3762 RM3962 Refrigerator Operating Instructions |
What you can safely check
- Record the alternating LP and temperature display before resetting.
- If the LP cylinder is empty, replace it before one documented front-panel restart.
- After a long shutoff or cylinder change, follow only the manual front-panel restart sequence and stop if the display returns.
Stop and call a technician for
- Repeated LP ignition failure, burner obstruction, LP hardware, and refrigerator control diagnosis are service-only.
Do not service LP hardware or ignition parts; use only the documented front-panel restart and call a Dometic dealer if LP returns.
Write this down before you call
- Interior data label model, product number, serial number
- Front display code or lamp state photo
- Power module/display board part number if service requests it
Other codes on Dometic RM3762 / RM3962 refrigerators
Full table: Dometic RM3762 / RM3962 refrigerators
- E0 No communication between the display and power module
- E1 A disconnected LP valve or hardware fault in the LP operation system; the refrigerator ma…
- E2 A failure of the temperature sensor device or associated electronic circuitry
- E3 A cooling unit malfunction
- E4 DC voltage out of range, above or below the manual limit values