Furrion refrigerator · 2 model lines
Furrion refrigerator code E2
Furrion documentation describes E2 separately for each model line: Furrion Arctic 10.6 cu. ft. 12V (FCR11DCGTA) (“Fan inside freezer compartment is defective”); Furrion Arctic 10.7 cu. ft. French door (FCR10DCGFA) (“Fridge sensor failure”). Compare the wording for your model below.
Check your model first. The same code can mean different things on different models. Find the model number on the appliance's data label, then use the matching row below.
What code E2 means by model
| Model line | What the manufacturer says | Source |
|---|---|---|
| Furrion Arctic 10.6 cu. ft. 12V (FCR11DCGTA) | The Furrion refrigerator manual lists E2 as fan inside freezer compartment is defective. | Furrion ARCTIC 10.6 Cu. Ft. 12V Refrigerator Instruction Manual |
| Furrion Arctic 10.7 cu. ft. French door (FCR10DCGFA) | The Furrion refrigerator manual lists E2 as fridge sensor failure. | Furrion ARCTIC 10.7 Cu. Ft. French Door Refrigerator Instruction Manual |
What you can safely check
- Record the code and check only for blocked vents from normal access.
- Record the code and refrigerator compartment temperature.
Stop and call a technician for
- Sensor, fan, compressor, inverter, communication wiring, model-mismatch, and sealed-system diagnostics should be handled by Furrion support or a qualified RV refrigerator technician.
Disconnect power before refrigerator service. Do not open electrical compartments, compressor wiring, inverter wiring, fans, sensors, or refrigerant systems unless qualified.
Write this down before you call
- refrigerator model
- displayed code
- battery/shore-power state
- door state
- ventilation clearance
Other codes on Furrion RV refrigerators
Full table: Furrion RV refrigerators
- E1 Voltage on compressor is too low or too high
- E12 Compressor inverter hardware failure
- E13 Temperature sensor in refrigerator compartment is defective
- E14 Temperature sensor in freezer compartment is defective
- E3 Compressor motor is stuck or system pressure is too high / Freezer sensor failure
- E4 Compressor runs with the wrong speed / Frosting sensor failure
- E5 Compressor inverter is too hot / Compressor start failure
- EH Input voltage to refrigerator is too high above 17 V
- EL Input voltage to refrigerator is low between 9.1 V and 10.6 V
- CS Sensor failure in the drinks box
- ES Failure of ambient temperature sensor
- Fd Defrosting sensor failure
- FF Fan failure
- FS Sensor failure in the freezing chamber
- RS Sensor failure in the refrigerating chamber
- UC Communication failure or model mismatch
- diagnostic LED flash 1 Voltage Fault: the input voltage is beyond normal parameters.
- diagnostic LED flash 2 Fan Fault Current: the fan's output current is more than 1 A peak.
- diagnostic LED flash 3 Compressor Start Fault: the rotor is blocked or system pressure is too high.
- diagnostic LED flash 4 Minimum Motor Speed Error: the compressor motor cannot maintain minimum 1850 RPM due to h…
- diagnostic LED flash 5 Thermal Fault: the system shut down due to high temperature from ambient conditions or th…
- diagnostic LED flash 6 Controller Hardware Fault: the controller detects abnormal parameters.
- E0 Door alarm because the fridge door has been open more than 5 minutes
- E1 OV ALM E1 with OV ALM icon: over-voltage alarm
- E1 UV ALM E1 with UV ALM icon: low-voltage alarm
- E6 Ambient temperature sensor failure
- EC Communication failure
- EF Fan failure
Related troubleshooting guides
- Furrion 12V refrigerator compressor cycling, low battery, or heat
- Furrion 12V refrigerator no power, service line, or reset
- Furrion refrigerator door seal or door not closing
- Furrion refrigerator moisture, ice, condensation, or defrost
- Furrion refrigerator normal noises, vibration, or rattling
- Furrion refrigerator not cold enough, seals, vents, or temperature
- Furrion refrigerator temperature mode, lock mode, or off-grid setting
- Furrion refrigerator service-only compressor, sensor, wiring, or refrigerant boundary