Onan generator · 1 model line

Onan generator code 49: Actuator Over Load

Onan documentation lists 49 as “Actuator Over Load”.

What code 49 means by model

What you can safely check

  • Reduce connected loads, especially air conditioners and battery chargers.
  • Record whether the fault clears with fewer loads.

Stop and call a technician for

  • Internal generator electrical output, inverter, controller, sensors, fuel system, ignition, AC circuit, and engine diagnosis belongs to Cummins service or a qualified generator technician.

Generators can produce carbon monoxide, hot surfaces, fuel hazards, moving-part hazards, and lethal voltage. Shut the generator down and do not open energized compartments unless qualified.

Write this down before you call

  • generator model/spec
  • hour meter
  • fault blink count
  • loads running when the shutdown occurred

Other codes on Cummins Onan QG 2800i / 2500i LP inverter generators

Full table: Cummins Onan QG 2800i / 2500i LP inverter generators

  • 1 High Engine Temperature
  • 4 Over Crank
  • 6 Low Oil Level
  • 12 Output Over Voltage
  • 13 Output Under Voltage
  • 14 Output Over Frequency
  • 15 Output Under Frequency
  • 19 Actuator Circuit Fault
  • 25 Alternator Over Voltage
  • 26 Alternator Under Voltage
  • 27 PMA Sense Lost
  • 29 Battery Over Voltage
  • 31 Engine Over Speed
  • 32 Crank Under Speed
  • 34 High Inverter Temperature
  • 35 EE Checksum Fault
  • 36 Mechanical Fault
  • 38 Output Over Load
  • 43 RAM Fault
  • 45 Crank Position Sense Lost
  • 52 Injector/Lift Pump Circuit Fault
  • 53 Oil Temperature Sensor Circuit Fault
  • 54 MAT Sensor Circuit Fault
  • 56 MAP Sensor Circuit Fault
  • 67 IGBT Over Current Fault
  • 74 Unprogrammed Board
  • 81 Alternator Stator Circuit Fault
  • 82 Vent Pressure Sensor Circuit Fault

Related troubleshooting guides

Official sources