Lippert slide-out · 1 model line
Lippert slide-out: Red LED 3
The Lippert In-Wall Slide-out troubleshooting manual maps Red LED 3 to Low Battery: voltage below 8 V DC at the start of cycle.
What this message means by model
| Model line | What the manufacturer says | Source |
|---|---|---|
| Lippert In-Wall slide-out controller | The Lippert In-Wall Slide-out troubleshooting manual maps Red LED 3 to Low Battery: voltage below 8 V DC at the start of cycle. | Lippert In-Wall Slide-out Troubleshooting and Service Manual |
What you can safely check
- Stop operating the slide.
- Check battery state from an installed monitor.
- Charge the RV battery before retrying if safe.
Stop and call a technician for
- Controller reset, motor synchronization, encoder checks, wiring repair, motor service, and manual override should follow Lippert documentation or qualified service.
Do not place hands or tools near moving slide mechanisms. Keep people clear and do not force the slide if current, short, or controller faults appear.
Write this down before you call
- controller label
- green LED motor indicator
- red LED count
- slide position
Other codes on Lippert In-Wall slide-out
Full table: Lippert In-Wall slide-out
- Red LED 2 Battery Drop Out: battery capacity low enough to drop below 6 V DC while running or a sho…
- Red LED 4 High Battery: voltage greater than 18 volts.
- Red LED 5 Excessive Motor Current: high amperage, also indicated by one side of the slide continual…
- Red LED 6 Motor Short Circuit: motor or wiring to motor has shorted out.
- Red LED 8 Wire Short Between Controller and Motor: encoder is not providing a signal, usually a wir…
- Red LED 9 Hall Power Short To Ground: power to encoder has been shorted to ground, usually a wiring…