Dometic rooftop air conditioner · 1 model line

Dometic rooftop air conditioner code P6: Condenser coil protection in cooling mode

Dometic documentation lists P6 as “Condenser coil protection in cooling mode”.

What code P6 means by model

Model lineWhat the manufacturer saysSource
Dometic FreshJet Series 4 / Series 7 (FJX)The Dometic FreshJet FJX operating manual lists P6 as condenser coil protection in cooling mode.Dometic FreshJet Series 4, FreshJet Series 7 Operating Manual

What you can safely check

  • Record P6, cooling mode, setpoint, outdoor conditions, and whether visible airflow paths are blocked.
  • Stop FreshJet operation from normal controls if the code returns.
  • Keep visible air intake openings, air nozzles, and ventilation grilles clear before service.

Stop and call a technician for

  • Condenser protection, temperature sensors, fan operation, sealed-system condition, and rooftop compartment diagnosis should be handled by authorized Dometic service or qualified RV HVAC personnel.

Disconnect power before any FreshJet service. Refrigerant-circuit, sealed-system, sensor, fan, drive, electrical protection, roof seal, and internal component work is for authorized Dometic service or qualified RV HVAC personnel.

Write this down before you call

  • Full FreshJet model and serial number from the data label
  • Wall control or display code photo
  • Shore-power or campsite voltage context and active loads
  • Recent service history and prior recurring codes

Other codes on Dometic FreshJet Series 4 / Series 7 air conditioners

Full table: Dometic FreshJet Series 4 / Series 7 air conditioners

  • P0 Over temperature or over current on the IPM module
  • P1 Under voltage protection
  • P2 Unit AC over-current protection
  • P3 Overvoltage protection
  • P4 Discharge tube overheat protection
  • P5 Evaporator coil protection in cooling mode
  • P7 Evaporator coil protection in heating mode
  • P9 Compressor drive abnormal or compressor does not start
  • E0 Communication failure
  • E1 Room temperature sensor fault
  • E2 Evaporator coil temperature sensor fault
  • E3 Condenser coil temperature sensor fault
  • E7 Outdoor temperature sensor failure
  • E8 Discharge tube temperature sensor failure
  • E9 Compressor drive or IPM module fault
  • EA Current sensor fault
  • EE Outdoor EEPROM fault
  • EL LIN-BUS/CI-BUS communication failure

Related troubleshooting guides

Official sources